Add a TFTP Listener
1. Go to Listener > TFTP Listener then click the Add (+) button located in the upper right corner.
2. You will get the fields as follows.
Refer to the following table to understand the fields in the above screen.
Name
A label or name that is assigned to a listener.
Trigger
You may want to assign the servers to a custom Trigger if target server is in an Isolated network or if you want to setup a scalable infrastructure. You will only see available Triggers in this field.
Authentication Protocol
UDP: User Datagram Protocol, on the other hand, is a connectionless protocol that offers low-latency, but lacks reliability mechanisms, making it suitable for real-time applications like video streaming and online gaming.
Log Interval
The interval for fetching data.
· Realtime
· 1 Minute
· 3 Minutes
· 5 Minutes
IP Address
The numerical label assigned to each device connected to a computer network is called an "IP address." An IP address is typically represented in the format XXX.XXX.XXX.XX, where each "XXX" is a number ranging from 0 to 255, and the "XX" is a similar two-digit number. IP addresses are used to uniquely identify and locate devices on a network.
Port Number
A specific endpoint for data exchange between two devices or applications within a network.
Status
To choose a server status such as:
· Active: Enables monitoring for server
· Maintenance: Enables maintenance mode for server and disables all notifications
· Reconnect: Restarts all collectors for server
· Disabled: Disables monitoring for server
Debug
To choose debug such as:
· Off
· On: Collects debug logs for Inventory and Monitoring Collector
3. After entering all the required info, click the button SUBMIT.
Last updated